How to Install a Belt on a Hoover Vacuum Elite. Verify that the vacuum cleaner is powered off and that the power cord has been disconnected from the wall. Lay the vacuum cleaner down so that the bottom of the vacuum is facing up. Identify the five screws that anchor the bottom plate in place, and remove them using a Phillips screwdriver. Remove the bottom plate. Pull the agitator roller from its housing and pull it free from the old belt, if it is still intact.
Throw away the old belt. Install the new belt around the motor pulley. Make sure that the belt is positioned so that the writing on the belt is on the outside. Place the agitator roller through the belt and adjust the position of the roller so that the belt lies on the belt guide. Secure the agitator roller back into the housing. Place the end of the roller opposite the belt into the rectangular slot, then stretch the belt to allow you to place the other end of the roller into place. Rotate the agitator roller to ensure that the belt moves smoothly.
- Hoover Vacuum Cleaner Belts. Hoover V Belt For Roller Brush. Hoover Elite, Elite-Rewind, Legacy, Dimension, W2, Fold-Away, Fusion Upright Flat Belt (2 Pack).
- How to Change the Belt on a Hoover Elite. Occasionally the belt on the Hoover Elite vacuum cleaner will break or wear out from usage, requiring it to be replaced.
- Replacement parts, filters, belts and bags are just. Your Hoover vacuum or carpet cleaner may also work with specialized add-on tools and accessories for hard.
Reinstall the bottom plate and secure it in place with the five Phillips- head screws.
Hoover Elite Supreme Upright Beater Belt Replacement. In this video I show you how I replace the beater belt on my very old Hoover Elite Supreme vacuum cleaner.
How to mend anything. Free repair help - change belt hoover elite supreme vacuum cleaner. The Hoover U5458-900 WindTunnel Supreme.
Place handle in operating position and turn cleaner over. To remove bottom plate, insert end of flat screwdriver into wide area of right- hand slot and push handle of screwdriver to the rear. Repeat in left- hand slot. Lift extension of bottom plate, rotate plate and remove fromcleaner body. Remove agitator and broken agitator belt. Then continue with step 5.)5.
Slip agitator through new belt (with lettering toward outside of cleaner) and position belt in belt guide. Push end of belt intoopening in cleaner body. Reposition agitator making sure toalign flat sides of projection on belt end of agitator with flat sides of slot in cleaner body. Place the three tabs on bottom plate into slots in front of cleaner body. Snap bottom plate into place over agitator. Master. Blaster. April 2.